ASME蓄能器使用说明书.docVIP

ASME蓄能器使用说明书 中国成都天人压力容器厂 厂址：四川省成都市新都开发区凌波西路 电话：028目录catalog 概述 General 收货检验 Preliminary checking 安装注意事项 Installation 初次运行 Initial operating 周期性检查 Periodic checks 蓄能器胶囊更换 Replacing of bladders 蓄能器的维护和预充气说明 The Instruction of Maintenance and Pre-charge Pressure ASME蓄能器零部件及易损件 ASME CODE Range repair kits list. 3000psi囊式蓄能器技术参数 Dimension 概述 蓄能器的铭牌上应有蓄能器的系列号或出厂编号。蓄能器的壳体上应有制造日期、允许的最大工装压力以及容量。 一般情况下，供货状态的蓄能器没有预充氮气。 注意：·蓄能器标注的允许工装压力必须大于系统的最大工作压力； ·装有蓄能器的设备，如果其液压回路要维修或需要连接其它元器件，必须先释放液压回路的压力； ·蓄能器壳体上不允许进行任何焊接或机械加工； ·必须使用氮气进行充气。充空气或氧气会引起爆炸。 General All accumulators carefully inspected and tested at the factory,and are exactly as designated by the code printed on the name plate fixed on gas valve side of each accumulator. On the name plate ,in addition to some instructions for use, is printed also the serial number.The accumulator can be supplied precharged with nitrogen if the client has given instrunctions in the order. The precharge value is indicated in a label on the name plate.On the accumulator shell are also printed: mnufacturer’s serial number ,manufacturer name, date of construction, capacity in litres, maximum working pressure in psi. ATTENTION: ·The max working pressure marked on the accumulator must be ≥than the calibrated pressure of the relief valve mounted in the hydraulic circuit. ·Before under taking any work (repirs,replacement, etc) on a hydraulic circuit mounting an accumulator. it is advisable to release completely the liquid pressure. ·Only Nitrogen must be used,air or oxygen could cause an explosion. 收货检验 用户收到蓄能器时应立即作如下检验： ·蓄能器运输途中发生的损伤； ·规格型号是否与订货代号一致； ·如提供的是没有初始负载的蓄能器，必须用氮气进行充气试验。 Preliminary checking Upon receipt check: 稵hat there has been no damage in transit. ?The identification code is as ordered. Before installation is most important to ensure thy at the as pressure corresponds to the desired value. 稩n the case of accumulators supplied without pre-loading pres