(建筑工程)第1章2(国外英文资料).doc

(建筑工程)第1章2 2A311020 building construction requirements 2A311021 familiar with civil building construction requirements Knowledge points: classification of civil buildings and calculation of building heights Classification of civil buildings Calculation of building height It can be divided into low layer, multi layer, middle and high level, high-rise and super high-rise. 1., the implementation of building height control area, building height, should be built outside the ground floor Calculation of the maximum height of buildings and structures 2. non construction height control area, the building height should comply with the design requirements 3. the building structure is provided with a non bearing wall, an ornamental component attached to the structure and an anchor Measures should be taken to strengthen the location of the firmware 4. buildings that do not allow prominent roads and red lines to be used are ground structures and Ancillary facilities 5., civil buildings should not be equipped with garbage pipes 6., the ventilation opening area of residential space should not be in hot summer, warm winter and hot summer and cold winter area Less than 8% of the floor area of the room, other areas should not be less than 5%. 7. disabled use of the door should comply with the relevant requirements Eight The main traffic with minimum width of stair handrail platform should not be less than the width of the ladder The upper and lower platform stairs aisle height should not be less than 2 meters, the ladder height Should not be less than 2.2 meters 9., public buildings, indoor and outdoor steps, step width should not be less than 0.3 meters, step height Not more than 0.15 meters 10. where the balcony, etc. should be set at the airport outside the protective railing, balustrade height should conform to Conformity requirement 11. all kinds of roof surface should be non burning material 12., masonry walls, toilets, baths, floors, etc., in the corresponding location should b