09.基础电路设计(九)高速数位电路板设计技术探索(国外英文资料).docVIP

09.基础电路设计(九)高速数位电路板设计技术探索 This article contributed by THE_ Pei DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Basic circuit design (nine) high speed digital circuit board design technology Content: the design of high speed digital Tour title, the 20 circuit board, high-speed circuit testing, tips and conclusion With the miniaturization and high speed market demand of digital electronic products, the design of digital circuit boards has attracted more and more attention. Since high-speed digital circuits are mostly composed of small CMOS components, this paper takes the FR-4 circuit board as a prerequisite to explore the design techniques of high-speed digital circuit boards. 20 tips for designing high speed digital circuit boards The use of low dielectric constant and low dielectric is connected to the circuit board The high rate of the circuit board is electrically induced to conduction electromagnetic field, and therefore vulnerable to noise interference, the general RF-4 dielectric rate is 4.8, the dielectric is now around 0.015; low induced circuit board rate is 3.5, the dielectric is then about 0.010. Because the price of the low lead rate circuit board is higher than that of the general circuit board, the selection must be made a comprehensive review. The limit frequency is 2.5G to 5.0GHz RF-4. It is thought that 60MHz is the speed of signal transmission on the circuit board of the limit, but the fact that the bus signal transmission speed of PC main board are more than 400MHz, if the current main board, can make such a high-speed signal transmission, the main reason is the use of shield (impedance) impedance of 60? About the pattern coated. Property is equal to the length of pattern, that is actually the circuit board does not exceed 2.5 to the physical limit of 5.0GHz signal transmission. Please try to use the multi-layer circuit board A multilayer circui