20140820实测通过6位数码管显示程序(c51)(国外英文资料).docVIP

20140820实测通过6位数码管显示程序(c51) 0.1 ~ 10 cumulative control digital tube low, 2 bit display, from 0.1 to 9.9 cumulative, step 0.1 Experimental source program: The main function of //***********************************************************************************// //*********************************************************************************** Void (main) / main function { Num=0; / / the initialization code is 0 While (1) / / while into the dead cycle { (scan); / / digital tube scanning function } } //*********************************************************************************** / / dynamic scanning function //*********************************************************************************** (scan) { Uchar i; For (i=0; i10; i++) { Show / / A P1=0xbf; //0xbf=1011 1111, that is, the strobe bit LE1=1; / / scientrans LE1=0; / / broken lock, 573 bit Q7~Q0 remains Wei=num*10; P1=dis[wei/10] 0x80 //dis[wei/10] |; 0~9 encoding, 0x80 = decimal point LE2=1; / / latch code LE2=0; / / broken lock, 573 Q7~Q0 remain selected Delay (100); / / delay hold excessive delay, flashing, delay is too small will be a ghost P1=0x00; LE2=1; LE2=0; / / remove P1 port data, in order to avoid ghosting Show a very / P1=0x7f; //0xbf=0111 1111, that is, the strobe is very bit LE1=1; / / scientrans LE1=0; / / broken lock, 573 bit Q7~Q0 remains Wei=num*10; P1=dis[wei%10]; //0~9 encoding LE2=1; / / latch code LE2=0; / / broken lock, 573 Q7~Q0 remain selected Delay (100); / / delay hold excessive delay, flashing, delay is too small will be a ghost P1=0x00; LE2=1; LE2=0; / / remove P1 port data, in order to avoid ghosting } If (num==9.9 num=0); / / scan to display 9.9, restart scanning Num+=0.1; //num plus 0.1 } /*********************************************************************************** The following procedure is measured by the 6 Yang digital tube display program (C51) 2014.08.20. measured by TX-3C imitation experiment board The crystal oscillator is 11.0592M ************************