高性能 低功耗 USB HUB FE11-datasheet.pdfVIP

USB 2.0 4-Port Hub Data Sheet Rev. 1.11 FE1.1 USB 2.0 HIGH SPEED 4-PORT HUB CONTROLLER _______________________ DATA SHEET _______________________ INTRODUCTION The FE1.1 is a highly integrated, high quality, high performance, low power consumption, yet FEATURES low cost solution for USB 2.0 High Speed 4-Port  Fully compliant with Universal Serial Bus Hub. Specification Revision 2.0 (USB 2.0); □ Upstream facing port supports High- It adopts Multiple Transaction Translator (MTT) Speed (480MHz) and Full-Speed architecture to explore the maximum possible (12MHz) modes; throughput. Six, instead of two, non-periodic □ 4 downstream facing ports support transaction buffers are used to minimize potential High-Speed (480MHz), Full-Speed traffic jamming. The whole design is based on (12MHz), and Low-Speed (1.5MHz) state-machine-control to reduce the response modes; delay time; no micro controller is used in this  Integrated USB 2.0 Transceivers; chip.  Integrated upstream 1.5KΩ pull-up, downstream 15KΩ pull-down, and serial To guarantee high quality, the whole chip is resisters; covered by Test Scan Chain – even on the high  Integrated 5V to 3.3V and 1.8V regulator. speed (480MHz) modules, so that all the logic  Integrated Power-On-Reset circuit; components could be fully tested before shipping.  Integrated 12MHz Oscillator with feedback S