NURBS曲面片的混合及填充.pdfVIP

Computer Science and Application 计算机科学与应用, 2016, 6(1), 21-29 Published Online January 2016 in Hans. /journal/csa /10.12677/csa.2016.61003 Blending and Filling of NURBS Patches * Nan Jiang, Yuehong Tang , Jieping Rao Department of Mathematics, College of Science, Nanjing University of Aeronautics and Astronautics, Nanjing Jiangsu th st th Received: Jan. 7 , 2016; accepted: Jan. 21 , 2016; published: Jan. 27 , 2016 Copyright © 2016 by authors and Hans Publishers Inc. This work is licensed under the Creative Commons Attribution International License (CC BY). /licenses/by/4.0/ Abstract This paper presents a method for subdividing the NURBS surface patches blending and N-sided hole filling by contour deletion method. First, surface blended according to the principle of non- uniform Catmull-Clark subdivision surface, and the non-uniform Catmull-Clark subdivision me- thod which builds the surface interpolating corner vertices and boundary curves was constructed. Then the contour deletion method was used to remove the control mesh boundary contour in the process of segmentation iteration. Last, N-sided hole filling was used to generate an integral smooth continuous surface. The method not only can guarantee the blending surface and the base surface patches C2 continuity at the boundary, but also can make the N-sided hole filling surface have better smoothness. Results show that, this method simplifies the specific computer realiza- tion process, broads the scope of application of subdivision surfaces, and solves the problem of incompatibility between subdivision surface and classic spline splicing