1.恒温槽测试思考题答案2（国外英文资料）.docVIP

1.恒温槽测试思考题答案2 Constant temperature tank assembly and performance test I. Experimental Skills 1, to set the experimental temperature of 25 degrees, how to adjust the thermostat? 2 、 adjustment and use of Backman thermometer. Reference answer: 1. temperature setting: (water, silver, electricity meter adjustment) Suppose the room temperature is 20 degrees, and the experimental temperature is 25 DEG C. The adjustment method is as follows: first, mercury contact thermometer is released The upper end of the spiral adjusting locking screw cap, and then moving the magnetic screw adjusting cap, the temperature indicating nut located approximately at 22 DEG C. Turn on the relay power, turn on the switch, turn on the heater and blender, work, and watch the thermometer reading. When reached At about 24 DEG C, the magnetic screw adjusting cap is rotated again, so that the contact and the mercury column are in a state of just connected and short opened. At this point Heat slowly until the temperature rises to 25 degrees, then tighten the locking screws. 2. adjust the Backman thermometer: The ruler reading method was used in the experiment The method directly utilizes the temperature gauge on the upper part of the Backman thermometer and does not need to be adjusted by a constant temperature bath First, the Backman thermometer is inverted, making the mercury in the lower mercury sphere and the Shui Yinlian in the auxiliary mercury tank above Then, standing over, put in the constant temperature trough has constant temperature in 5 minutes, when Mercury stays in the meter under the auxiliary mercury storage tank A scale on which the mercury is raised; the mercury rises 2.5 small squares (about 5 degrees) on the original scale; immediately The Backman thermometer is re placed in a thermostatic bath to allow the mercury column to be placed between 1~4. Two, ask questions: 1. thermostatic groove structure, the role of each component. 2. how to improve the sensitivity of thermostatic ba