2009年广东省高考数学试题B卷(理数)（国外英文资料）.docVIP

2009年广东省高考数学试题B卷(理数) Judgment question (two) when the vernier caliper is attached to each other, the zero line of the ruler and the cursor should be aligned. B. Judgment question (2) the front angle of each point on the arc blade of the standard group drill is reduced before the sharpening of the circular arc blade, the wedge angle is increased, and the intensity is increased. * Judgment question (standard) the drill has a symmetrical chip separation groove at the back. * Judgment question (standard) a slot on a standard drill can narrow the width of the chip, thereby allowing the chip to flow smoothly. B. Judgment question (drilling) the drill of brass to reduce the front angle at the outer edge to avoid sticking. B. Judgment question () drill sheet group drill is pointed centering by fulgurating. B. Judgment question (0-25mm) the micrometer shall be placed at a certain clearance between the two measuring surfaces. B. Judgment question (drilling) a well lubricated cutting fluid, in addition to cooling, is more important than lubrication. B. Judgment question (bit) the back angle of the main cutting edge of the bit, the maximum at the edge and the smaller the center at the nearer. * Judgment question (2) when the vise clamps the workpiece, it can be sheathed with a long tube to tighten the handle so as to increase the clamping force. * Judgment question (drilling holes) because the drill bit is very high, the drill cools quickly in the air, so there is no need for cutting fluid. * Judgment question The hole between the center line of the hole and the end face of the hole must be drilled by drilling the inclined hole. B. Judgment question (fluid action pumps) transport fluids by the energy of fluid flow. B. Judgment question (b) when drilling deep holes with deep holes, a cutting fluid, such as a certain amount of pressure, can be used to keep the chip free. B. Judgment question () when drilling a deep hole with a length drill, it does not need to drop out of the chi