2011秋石油大学机械设计在线作业(全部)（国外英文资料）.docVIP

2011秋石油大学机械设计在线作业(全部) Third online homework Assignment First, when the parts may appear plastic deformation, should be calculated according to rigid criteria. Your answer: wrong Subject score: 0.5 Score: 0.5 Annotation: strength criterion Second, parts of the surface damage mainly corrosion, wear and contact fatigue. Your answer: right Subject score: 0.5 Score: 0.5 Note: part failure form Third, the higher the tempering temperature of the steel, the lower the hardness and strength, the better the plasticity. Your answer: right Subject score: 0.5 Score: 0.5 Comments: tempering reduces hardness and strength and improves plasticity and toughness Fourth, the design phase of a machine is the key to deciding whether a machine is good or bad. Your answer: right Subject score: 0.5 Score: 0.5 Annotation: the role of design Fifth, fatigue damage is the main cause of most mechanical parts damage. Your answer: right Subject score: 0.5 Score: 0.5 Note: the main failure form of the component Sixth questions? The reliability of a component is always constant as the work time goes on. Your answer: wrong Subject score: 0.5 Score: 0.5 Remarks: fatigue life decreases The seventh key is to transfer the load on both sides of the key. Your answer: right Subject score: 0.5 Score: 0.5 Annotation: the work surface of flat keys Eighth question spiral auxiliary self-locking condition is: the thread elevation angle y 3 equivalent friction angle R Your answer: wrong Subject score: 0.5 Score: 0.5 Annotation: self locking condition In the ninth hinge reaming bolt connection, the bolt of the reaming system takes the tension and the shearing force. Your answer: wrong Subject score: 0.5 Score: 0.5 Remarks: hinged bolts are subjected to shear only Tenth. The nominal diameter of the standard cylinder thread is the middle diameter. Your answer: wrong Subject score: 0.5 Score: 0.5 Annotation: big diameter In the eleventh question belt drive, the belt on both sides of the belt wheel will form a loose sid