500程控（国外英文资料）.docVIP

500程控 Err1: the fluctuation range of power supply is over (over 10%) 1, the external power supply voltage fluctuation range is indeed more than + 10% Resolvent： Please users with the local power supply units (such as power supply bureau) for help. The user to purchase investment if the external power supply regulator, although fluctuation range of more than 10%, but relatively stable, can purchase sufficient capacity regulator. In the use of voltage regulators, you must install the exposure process regulator, adjust the lock circuit, otherwise it will cause damage to the console and voltage regulator. 2, the power board (No. 1 board), the power supply sampling value range (DC11V~DC9V) Solution: check whether the voltage between the resistor R1 and potentiometer R2 in the power board is between the DC 11V~9V and can not be satisfied, then adjust the potentiometer R2 to satisfy it: V=V enters /380 * 10 (V into current measured voltage) 3, power board (No. 1 board) in the power supply sampling point (between R1 and R2 position) before the circuit fault Solution: check the resistor R1 and potentiometer R2 before the circuit components, such as transformers, T1, silicon bridge, V1, safety tube F1, diode, V2, etc.. Replace the damaged components. 4, power board (No. 1 board) +15V power failure Solution: check the power panel test point TP10 point voltage is normal (+ 15V + 0.2V~ + 0.1V). When the voltage is too low, there may be a short circuit inside the machine, or LM338 (LM7815) damage, repair or replacement. 5, the power board (No. 1 board) in the device D1, D2, V7, V8 work abnormal Solution: check D1, D2, V7, V8 each point work voltage, determine the abnormal work of the device, to be replaced. 6 、 the interface between the power board (No. 1 board) and the computer board (No. 8 board) is working abnormally Resolvent： To check the power supply board (1 boards) and computer board (8 boards) between the connector is reliable contact, to repair the unreliable. Check the