705吹扫方案（国外英文资料）.doc

705吹扫方案 First, the purpose and scope The equipment and pipelines will bring various impurities in the installation process, such as welding slag, dust and so on, in the pilot car it is necessary to purge out, to prevent accidents of the valve action and equipment in operation; at the same time, the operation personnel familiar with the process. The range of flushing includes 701 and the pipe in the inner pipe corridor (except the pipeline before entering the boundary zone). Two, technical requirements 1, the steam pipe system by the same level of steam blowing, water system as much as possible by the system of pump for flushing, pipeline gas path system and the other cannot use the pump to wash, use low pressure nitrogen or compressed air purge. 2, the order of blowing washing should be in accordance with the general manager, the main branch, the branch pipe, the drain pipe, the instrument guide pipe, from near to far in turn, and each system branch should be blown separately. 3, the valve group: first purge valve manual valve and bypass valve group before disconnecting the purge (Flushing), then the valve replaced the short purge (Flushing), bypass and drain should purge (flushing). 4, single pump purge: front flange pump or pump body before the short break, then rinse import pipeline, installation of temporary filter in the import pipeline (or with the original pipeline with the filter), the return line on the orifice flange into the device before the demolition and broken open flushing pump return line. 5, when the purge medium to go through the equipment, and equipment connected upstream pipeline, must first sweep clean, in case debris into the downstream pipeline, equipment. If the blow - out port is placed before the stationary equipment, it is difficult to set aside the cleaning convenience. The blowing medium can enter the equipment and the equipment must be cleaned. 6, utilities pipeline with its transport fluid cleaning medium blowing (flushing). 7. The bl