光纤收发器指示灯含义（国外英文资料）.docVIP

光纤收发器指示灯含义 The meaning of fiber optic transceiver indicator light: The fiber optic transceiver has 6 LED instructions that show the operating status of the transceiver and, as shown in LED, can determine whether the transceiver is working properly and what might be the problem, thus helping to identify the fault. Their functions are as follows: PWR: the light indicates that the DC5V power is working properly FX 100: light indicates fiber transmission rate of 100Mbps FX Link/Act: the length of the light indicates that the fiber link is properly connected; the light flashes to indicate that data in the optical fiber is transmitted FDX: the light indicates that the optical fiber transmits data in full duplex mode TX 100: the light is on the twisted pair, the transmission rate is 100Mbps; the light is not bright, indicating the twisted pair, the transmission rate is 10Mbps TX Link/Act: the length of the light indicates that the twisted pair link is true; the light flashes to indicate that data in the twisted pair is in transmission The following is the help of diagnosing the faults of each lamp: A, such as the optical transceiver (FX) indicator light does not shine, please confirm whether the fiber link cross links? The fiber jumper is connected in one parallel manner, and the other end is connected in a cross way. B, such as A optical transceiver (FX) indicator lights, B optical transceiver (FX) indicator light does not shine, then the fault in the A transceiver: one possibility is: A transceiver (TX) optical transmission has been bad, because the B transceiver interface (RX) to receive the optical signal; the other one possibility is that the A transceiver (TX) of the optical fiber link to send port problems (cable or light jumpers might be broken). The C and twisted pair (TP) lights are not on. Please make sure the twisted pair is faulty or connected incorrectly Please check with an off and off tester. (however, some of the transceivers twisted pair lights must be sw