动稳定及GTO（国外英文资料）.doc

动稳定及GTO Definition: Heat stable current is the old name, now known as rated short-time withstand current (IK) Under specified conditions of use and performance, the effective value of the current carried by the switching device and the control device at the switch position in a specified period of time. The standard value of the rated short-time withstand current shall be selected from the R10 series specified in the GB762 and shall equal the short-circuit rating of the switchgear and control equipment. Note: the R10 family includes numbers 1, 1.25, 1.6, 2, 2.5, 3.15, 4, 5, 8, 6.3, and their product with 10N Dynamic steady current is the old name, now known as: rated peak tolerance current (IP) Under specified conditions of use and performance, the rated current of the switching equipment and the control equipment can be rated at the closing position, and the peak value of the first half of the wave. Rated peak tolerance current shall be equal to 2.5 times rated short-time withstand current. Note: according to the characteristics of the system, more than 2.5 times the rated short-time withstand current may be needed. Rated short-circuit duration (TK) 8] The time interval between the switching device and the control device that can hold the rated short-time withstand current in the closing position. The nominal value of the rated short-circuit duration is 2s. If needed, you can select values less than or greater than 2s. The recommended values are 0.5s, 1s, 3S, and 4s. 2. determine the conductor cross section according to the rated short-time withstand current: The formula GB3906[in Appendix D]: S=I/a V (t delta theta) Type: I-- rated short-time withstand current; a material coefficient of 13 copper, aluminum is 8.5; t-- rated short duration; delta theta - Wen Sheng (K), for the bare conductor and generally 180K, for the duration of 4S 215K. Then: 25KA/4S copper bus minimum cross-sectional area S= (25/13) 4/215=260 mm2 * * 31.5KA/4S copper bus minimum cross-sectional