钢筋图集03G101常识（国外英文资料）.docVIP

钢筋图集03G101常识 Steel Atlas 03G101 common sense,.Txt occasionally look back, otherwise, always in search of, and do not know what they lost. Men pay for lovers, women pay for relationships, men and women grab money for friends. Men love to see the woman with their eyes, the most vulnerable to beauty, women love to see the man, the most vulnerable to grief torture. Reinforced bar Atlas 03G101 common sense (1) Reprinted from leaves, reproduced in 2010, 08, 11 08:41 read (0) review (0) categories: personal diary Report 1: compares 0.4LaE+15d to LaE for its big value, right? 1, do not compare 0.4LaE+15d with LaE. LaE is the direct anchor length standard. When the anchor is bent, the anchorage of the steel bar at the bend point changes the nature of the hair, so it should not take LaE as the standard to measure the total length of the bent anchor, otherwise it is a mistake in concept. It can be seen that 0.4LaE+15d and LaE are two different concepts, and there is no comparable premise. Please look at the label 2, 03G101-1 Atlas fifty-fourth page frame beam end support of the following: extending to the outside of the column (column longitudinal reinforcement inside), this is the first, and the back half of the sentence and 0.4LaE is a requirement for checking straight anchor horizontal section length. This requires that we first let the beam longitudinal stretch to the outside of the column, and then check the straight anchor horizontal section length, can only be longer than 0.4LaE, and not shorter than 0.4LaE. 3, as for the vertical end of the longitudinal beam of the frame beam, the straight hook of 15d is a construction requirement. Construction requirements are a technical requirement for concrete structures. The construction requirements are not to be calculated and must be performed. As for why should be specified as 15d? Professor Chen said, this is a mechanical test, in the straight hook on the 5D to 10d, there are internal forces (deformation), there is no place t