材料题2（国外英文资料）.docVIP

材料题2 Fill in the blanks 1. for open porous materials, when the porosity increases, the density, water absorption, frost resistance, thermal conductivity and strength of the material. 2. compared with Portland cement, the hydration heat of the pozzolanic cement, the ability to withstand soft water, dry shrinkage 3. thermal insulation materials should be selected for thermal conductivity, specific heat capacity and heat capacity of the material 4. of the hydrated products of silicate cement are colloids and 5., ordinary concrete sand, mud content increases, concrete shrinkage, frost resistance 6. the three parameters in the mix design of ordinary concrete should be the sum of 7. in steel, the element S will increase the steel mainly, the element P will make the steel increase mainly 8. moisture content of 1% of wet sand 202 grams, of which water for grams, dry sand grams 9., compared with Building lime, building gypsum setting hardening rate, hardening volume 10., the greater the content of oil in asphalt, the temperature induction of asphalt and the stability of the atmosphere 11. according to the national standard, the initial setting time of Portland cement should be satisfied. 12., the workability of crushed stone concrete is better than that of pebble concrete under the same conditions. 13. lime treatment is mainly to eliminate the harm. 14. steel grades Q235-AF, A said. 15. structural design, the strength of hardened steel by value. 16. choice of building envelope materials, should be used in thermal conductivity thermal capacity is more _______________, _______________ materials, to ensure a good indoor climate. 17. reinforced concrete structure with steel bar in round bars with _______________ symbols, ribbed bars with _______________ symbols. 18. steel structure design, based on the value of the strength of steel for _______________. 0. O 2, 0.2 said the significance for _______________. Concrete work of 19. continuous gradation aggregate is good, not easy to