叉车12(国外英文资料).docVIP

  • 3
  • 0
  • 约2.11万字
  • 约 51页
  • 2017-07-05 发布于河南
  • 举报
叉车12(国外英文资料)

叉车12 Forklift driver practice Answer: Liu Zhongwen practice score: 100 points: Judgment question The center wheel of the planet gear of the 1: loader is connected with the turbine of the hydraulic torque converter, and the outer gear ring and the planet carrier are connected with the output shaft of the transmission. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: The 2: clutch is difficult to drive and difficult to drive. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: The 3: tractor shall use at least two ordinary cardan joints. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: The fork 4: forklift steering bridge. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 5: forklift loading machine and a steering wheel without big, many units has been canceled. (N) Right and wrong Examinee answer: Correct answer: Wrong Test scores: 1 points: The 6: water temperature meter is used to indicate the temperature of the cooling water in the jacket when the engine is running. It is expressed in degrees centigrade. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 7: when the water temperature warning light is red, indicates that the engine cooling water temperature is too high. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 8: before starting the engine, you should tighten the hand brake first, then shift the lever into neutral. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 9: vehicles with front wheel steering produce internal wheel differential when cornering. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 10: new cars are not allowed to slide when towing vehicles. (Y) Right and wrong Examinee answer: Correct answer: Yes Test scores: 1 points: 11: intake valve opens at 10 degrees to 30 degrees before the piston reaches tdc. (Y

文档评论(0)

1亿VIP精品文档

相关文档