材料单选题（国外英文资料）.docVIP

材料单选题 Construction materials 1, the strength of ordinary concrete grade is guaranteed by 95% (B) days of standard size cube compressive strength Degrees are represented by values. A, 7, B, 28, C, 3, 7, 28, D, (A+B) 2. The penetration test of asphalt can be used to determine the penetration of (D) needle. A, viscous bitumen, B, liquid petroleum asphalt, C, emulsified asphalt, evaporation residue D, A+C 3, when mixing concrete, it is found that the water holding property of the mixture is poor, and measures should be adopted (A) to improve it. A, increase sand rate B, reduce sand rate C, increase cement D, reduce water cement ratio 4, the biggest influence factor to the concrete mixing logistics dynamic is (D). A, sand rate B, cement variety C, aggregate gradation, D and water consumption 5, a certain batch of Portland cement has been tested and its volume stability is not good, then the cement (A). A, shall not use B, can be used in secondary engineering, C, and can reduce the intensity of use D can be used in engineering, but must be improved 6. When determining the setting time of cement, when the test needle sinks to the bottom plate (A), that is, the cement reaches the initial setting. A, 4mm, + 1mm, B, 2mm ~ 3mm, C, 1mm ~ 2mm 7, with the increase of asphalt content, the porosity of asphalt mixture (A). A, decrease B, increase C, decrease first, then increase D, increase first and then decrease 8. The concrete mixture is stratified and separated, indicating that (B). A, poor mobility, B, poor cohesiveness, C, poor water retention, D, A+B+C 9, cement mortar strength test three, test body 28 days flexural strength is 7.0MPa, 9.0MPa, 7.0MPa, flexural strength test result is (A). A, 7.0MPa, B, 7.7MPa, C, 9.0MPa, D, 8.0MPa 10, cement initial setting time does not conform to the regulation is (B), the final setting time does not conform to the regulation is (A). A, nonconforming product, B, reject 11, under the condition of penetration and elongation unchanged, the sof