钢筋计算方式（国外英文资料）.docVIP

钢筋计算方式 Hook length in the stirrups stirrup count how to calculate the value of the general experience of how satisfied answer: 1 flat drawing, the stirrup hook length LW is such a requirement: when the stirrup reinforcement, end hook is 135 degree earthquake: LW = max: (11.9d, 75+1.9d); general stirrup: LW = 6.9d., when the stirrup reinforcement end hooks for 180 degrees: Earthquake: LW = 13.25d; LW = 8.25d when ordinary stirrups, stirrup reinforcement end hooks for 90 degrees: Earthquake: LW = 10.5d; LW = 5.5d with ordinary stirrups: Answer 2: hook 90 degrees, the general structure of 5.5d; seismic architecture 10.5d, the hook is 135 degrees, the general structure of 6.87d; seismic architecture 11.87d, the hook is 180 degrees, 8.25d; seismic architecture for 13.25d. Length of single stirrup = outside section of component section -8* protection layer +4* stirrups diameter + bend hook increase length Number of stirrups = (length of member steel reinforcement thickness) / spacing of stirrups +1 Length of stirrups = length of single stirrup length * number of stirrups Hanger length = 2* (20d) +2* cable anchorage length + width +2*50 beam, the frame beam height 800mm angle of =60 DEG to =45 DEG 800mm angle Length of inclined section =1.414* (height of main beam -2*, thickness of protective layer) Note: if the main beam is too high, special treatment must be taken The length of the beam steel bar = the axis dimension of the beam plate - protective layer (general 25) + top bending hook size 180 degrees hook =6.25d 90 degrees hook = 3.5D 45 degrees hook = 4.9d Salty again to measure the difference: 30 degrees 0.3d, 45 degrees 0.5d, 60 degrees 1D, 90 degrees 2D and 135 degrees 3D If it is a general construction drawings, according to the above method can be calculated, such as the distribution of the plate beam \ negative disk \ beam longitudinal stress bar \ frame bar. If it is flat construction drawings, it should refer to the 03G101-1B Length of stirrups: length of outso