cadence中建立元件的流程(外国英文资料).docVIP

cadence中建立元件的流程 Part creation In Allegro, there are five kinds of Symbol, they are Package, Symbol, Mechanical, Symbol, Format, Symbol, Shape, Symbol, Flash, Symbol. Each Symbol has an Symbol, Drawing, File (symbol drawing file), and the suffix names are *.dra. This drawing file is for editing only and cannot be called to the Allegro database. Allegro can call Symbol as follows: 1.Package Symbol The package symbol for the general element, the suffix *.psm. All the components in PCB, such as resistors, capacitors, inductors, IC and so on, are Package Symbol. 2.Mechanical Symbol An institutional symbol consisting of an outer frame and a screw hole, with the suffix *.bsm. Sometimes we design the outline of PCB and screw hole position is the same, such as video cards, computer motherboards, each time the design of PCB, to draw a plate frame and determine the location of the screw hole, it seems troublesome. At this point, we can build the PCB frame and the screw hole as a Mechanical Symbol. When you design the PCB, you can transfer the Mechanical Symbol. 3.Format Symbol The element symbol consists of the frame and the suffix *.osm. Less use. 4.Shape Symbol For special shape pads, suffix *.ssm. Like the finger pad graphics package is an irregular shaped pad, should first be irregularly shaped pad shape into a Shape Symbol in the establishment of the pad, and then in the establishment of pads to call this Shape Symbol. 5.Flash Symbol The pads connect copper skin symbols, and the suffix is called *.fsm. In the PCB design, the pad with the surrounding copper can be connected, contains, can also be used on plum connection, we can distinguish the plum into a Flash Symbol, call the Flash Symbol in building pad. The most widely used is Package symbol, which is the part with electrical characteristics, and PAD is the foundation of Package symbol 1) building PAD Start Padstack Designer to make a PAD, and PAD is divided into categories by type: 1. Through, perforative; 2. Blind/Bu