密封焊接作业指导书(中英双语)概要1.doc

密封焊接 施工作业指导书 Site Execution Guidebook  目 录 LIST 1 编制依据 1 Compiling Sources 2 作业项目概况及工作量 1 Briefly Introduction to Construction Items and Working Amounts 3 作业必备条件 1 Working Necessary Terms 4 作业顺序、方法及要求 5 Working Sequence, Methodology and Requirement 5 作业过程对质量控制点的设置 9 To set up quality controlling term in process of working 6 作业结束的检查验收和应达到的质量标准 10 Inspection acceptance after achievement and required quality standard 7 作业的安全要求及措施 12 Safety Requirement and Protective Measures 1编制依据 Compiling Sources 1.1《火力发电厂焊接技术规程》DL/T869-2004 Welding Technical Regulations of Thermal Power Plant DL/T869-2004 1.2电站钢结构焊接通用技术条件DL/T678-1999 General Technical Terms of Steel Structure Weld in the Power Plant DL/T678-1999 2作业项目概况及工作量 Briefly Introduction to Construction Items and Working Amounts 2.1 概述: BRIEF 锅炉采用无锡华光锅炉股份有限公司生产的高温高压循环流化床锅炉。其型号为：UG-430/9.8-M。 This Boiler is performed as High-temperature high-pressure Circulating Fluidized Bed Boiler made by WuXi Huaguang Boiler Manufacture Corporation LTD. And the type is UG-430/9.8-M 3.作业必备条件 Necessary Working Conditions 3.1本项工程配备焊工8--12人，参加焊接工作的施工人员必须有相适应的考试合格证，并经有关人员确认后方可进行焊接工作，施工人员须具备良好的施工工艺作风。 3.1 8-12 Welders should be designated to this Project, who are with correspondent welding certificate and to be allowed to carry out welding after being approved confirmed by regarding personnel, and should be reliable for proper construction technical characteristics. 3.2 配备直流逆变电焊机8—12台以及相应的二次线、配备相应焊工所需用的面罩、把钳、白光防护镜、绝缘手套等劳动防护用品。 3.2 8-12 sets of DC inverter welding machines should be equipped as well as secondary cables accordingly, and necessary working protection facilities in terms of masks, pliers, goggles and insulation handgloves should be provided for welders. 3.3 所用焊接材料必须有制造厂材质合格证、出厂日期证明。 3.3 All of the flux utilized in the welding work should be with approved certificate and factory release-date certificate of manufacturing materials. 3.4 施工时必须有防雨措施，施工场地安全设施齐全、规范，设备、工具堆放整齐。 3.4 Rain-proof measures should b