16位输入边沿定时捕获.docxVIP

源程序清单见程序清单1，其中黄色背景红色字体为错误的代码。该程序的功能是测量方波信号的频率，由串口输出显示。基本思路是：利用Timer0的TimerB的16位PWM功能产生一个方波作为被测信号，利用Timer2的TimerA定时捕捉功能捕捉被测信号的相邻两个上升沿，利用两次捕捉时的计数值计算出被测信号的频率。程序清单1?实验源程序（有误）#include??systemInit.h#include??uartGetPut.h#include??timer.h#include??stdio.h??#define??PART_LM3S1138#include??pin_map.h??//??在CCP1管脚产生1KHz方波，为Timer2的16位输入边沿定时捕获功能提供时钟源voidpulseInit(void){????SysCtlPeriEnable(SYSCTL_PERIPH_TIMER0);?????????????????//??使能TIMER0模块????SysCtlPeriEnable(CCP1_PERIPH);??????????????????????????//??使能CCP1所在的GPIO端口????GPIOPinTypeTimer(CCP1_PORT, CCP1_PIN);??????????????????//??配置相关管脚为Timer功能?????TimerConfigure(TIMER0_BASE, TIMER_CFG_16_BIT_PAIR |?????//??配置TimerB为16位PWM????????????????????????????????TIMER_CFG_B_PWM);?????TimerLoadSet(TIMER0_BASE, TIMER_B, 6000);???????????????//??设置TimerB初值????TimerMatchSet(TIMER0_BASE, TIMER_B, 3000);??????????????//??设置TimerB匹配值????TimerEnable(TIMER0_BASE, TIMER_B);}??//??定时器16位输入边沿定时捕获功能初始化voidtimerInitCapTime(void){????SysCtlPeriEnable(SYSCTL_PERIPH_TIMER2);?????????????????//??使能Timer模块????SysCtlPeriEnable(CCP4_PERIPH);??????????????????????????//??使能CCP4所在的GPIO端口????GPIOPinTypeTimer(CCP4_PORT, CCP4_PIN);??????????????????//??配置CCP4管脚为脉冲输入?????TimerConfigure(TIMER2_BASE, TIMER_CFG_16_BIT_PAIR |?????//??配置Timer为16位事件定时器????????????????????????????????TIMER_CFG_A_CAP_TIME);?????TimerControlEvent(TIMER2_BASE,??????????????????????????//??控制TimerA捕获CCP正边沿??????????????????????TIMER_A,??????????????????????TIMER_EVENT_POS_EDGE);?????TimerControlStall(TIMER2_BASE, TIMER_A, true);??????????//??允许在调试时暂停定时器计数????TimerIntEnable(TIMER2_BASE, TIMER_CAPA_EVENT);??????????//??使能TimerA事件捕获中断????IntEnable(INT_TIMER2A);?????????????????????????????????//??使能TimerA中断????IntMasterEnable();??????????????????????????????????????//??使能处理器中断}??//??定义捕获标志volatiletBooleanCAP_Flag = false;??//??测量输入脉冲频率并显示voidpulseMeasure(void){????unsigned short i;????unsigned short usVal[2];????char s[40];?????TimerLoadSet(TIMER2_BASE, TIMER_A, 0xFFFF);?????????????//??设置计数器