感应电条件下的电流互感器误差测试方法分析!.pdfVIP

内蒙古电力技术 2017 年第35 卷第2 期 INNER MONGOLIA ELECTRIC POWER 75 doi:10.3969/j.issn. 1008-6218.2017.02.021 感应电条件下的电流互感器误差测试方法分析 王 达，杨朋威，张 平，贺鸿鹏，韩晋思 （国网内蒙古东部电力有限公司电力科学研究院，呼和浩特 010020 ） 摘要：针对呼伦贝尔某电厂2 条500 kV 出线的电流互感器误差测试工作，开展了感应电 条件下的互感器误差测试方法研究。分析了采用目前常用的2 种互感器误差测试方法，即比 较法和低校高方法的误差产生原因。提出了适用于存在感应电条件下误差测试的2 种接线 方法，即拆除一次连接线和悬挂人工接地线。采用悬挂人工接地线方式，分别用比较法和低 校高方法进行了实际测试，测得的误差结果均能够满足相关标准要求。 关键词：同塔双回输电线路；电流互感器；感应电；误差测试 文献标志码：B 中图分类号：TM452 文章编号：1008-6218（2017 ）02-0075-04 Analysis of Current Transformer Error Test Method Under Induced Electricity WANG Da, YANG Pengwei, ZHANG Ping, HE Hongpeng, HAN Jinsi （Electric Power Research Institute of State Grid East Inner Mongolia Electric Power Company Limited, Hohhot 010020, China） Abstract ：Based on the two 500 kV outlets error test of the current transformers in a power plant in Hulunbeier, carry out the current transformer error test under the induced electricity. In this paper, make an analysis of two common transformer error test methods of comparative method and low calibration method for the cause of error and the error effect on the test results. Two kinds of wiring methods suitable for the test under the presence of induced electrical conditions were proposed, which were the removal of the primary connection line and the suspension ground wire. The correctness of the suspension ground wire was proved by the comparative method and low calibration method. The error gained could meet the s