二极管三极管的测量（Diode triode measurement）.docVIP

二极管三极管的测量（Diode triode measurement） The diode is measured with a digital multimeter diode. When a diode is used, the gear of a multimeter diode is used. If the red pen is connected with the diode (positive) pole, the black pen takes the diode (negative) pole, the diode is in the positive direction, and the multimeter has a certain value. If the red surface pen is connected with the diode cathode, the black surface is connected with the diode anode, the diode is in the anti-bias, and the multimeter high is displayed as 1 or a large number, indicating that the diode is good. If both of the measurements are small, the diode is short-circuited. If the values of the two measurements are both large or high, the inside of the diode is open Measure triode with a digital multimeter (1) the type of the triode and the base b are measured with the diodes of the digital multimeter When judging, the triode can be regarded as a back-to-back PN junction, as shown in figure 2.1. According to the method of judging diodes, one of the most common positive or public negative is determined, which is the base b. For the NPN tube, the base is the public anode; The PNP tube is the public negative. Therefore, it is known that the triode tetrode is NPN or PNP triode. (2) the judgment of emitter e and collector c Using multimeter to measure the position of beta (HFE) values, the emitter e and collector c were judged. Screw gear to MFE base insert the corresponding types of the hole, put in the pin hole respectively inserted into the c and e observation data, then c, e hole of pin switch to see data, numerical big shows on the pin. (3) judge the quality of the triode The test is used to test the triode emission junction, the positive and anti-deviation of the collector, the normal triode is good, or the triode is damaged. If the public b pole is not found in the measurement, the transistor is also a bad pipe. Specific approach is to build the multimeter to electric block R x 1 k block, with red