口腔修复学0303（Oral prosthetics 0303）.docVIP

口腔修复学0303（Oral prosthetics 0303） (6) impression and model The model and perfusion model of the repair type of tooth defect are basically the same, and the method has the following aspects: To make the impression of the shape and size of the teeth, select the appropriate pallet and require the tray to be able to cover the adjacent teeth in the near and far above the teeth. The powder and liquid or powder and water are used strictly according to the instructions of the manufacturer of the elastic impression material. First, take a small amount of the printed material with your finger, press the hole inside the nest, make the gas overflow inside the hole, then send the tray to the population, keep the tray stable, and then gently remove the material after it solidifies. The impression shall be clear and complete. After determining the impression of the seal, remove the supernumerary material from the outside edge of the pallet, and take the right of the mandible and record into the center wax. In addition, AGAR and rubber seal materials can be used. The clarity, accuracy and volume stability and elasticity of its impression are superior to alginate seal material. It is the best material for rubber stamping material. 2. The irrigation model and the production of removable generation can be made in two ways, namely, the irrigation work model and the nailing method. (1) the working model and add nail method: in the middle of the tooth preparation of impression, along the long axis direction insert a conical polyhedron metal post or nail, pile head should be slightly bigger than the roots, formation of concave or dentate, to facilitate the retention of pile and man-made stone. Place the root of the pile in a small clip, determine the head position of the pile in the center of the preparation of the tooth, and do not contact with the impression material, and the root is arranged in the direction of its long axis. Attach the ends of the clip to the edge of the tray and make