口腔修复学0302（Oral prosthetics 0302）.docVIP

口腔修复学0302（Oral prosthetics 0302） 3. Treatment steps (1) preparation of metal inlaid teeth Inlay (inlay) is a kind of embedded crowns nest inside the hole, to restore the defect of teeth morphology and function of restoration, according to preliminary preparation good nest hole shape, using different materials in the outlets and socket hole consistent and anastomosis of the restoration, through the mouth after we try and adjust the appropriate, reoccupy cement adhesive to nest inside the hole. 1. The main points of the tooth preparation inlay nest holes in the preparation of the main principles and requirements, such as the removal of humus, do preventive extension, flat on the floor of the cave, the wall straight, Angle of point, line clear, etc., all holes and filling body shape for the same, but it also has its own characteristics. (1) the hole has no recessed: all the shaft walls of the inlaid holes cannot be concave, and they should be parallel to each other, otherwise the wax type is difficult to take out, and the restoration is more difficult to take place. To facilitate the wearing, allow each micro shaft wall to face outreach 2 ° ~ 5 °. (2) the margin of the hole is inclined: the surface of the cavity in the tooth enamel on the edge of the socket. The purpose is: to prevent the fracture of the non-base glaze at the edge of the hole, which causes cracks in the edge of the repair body and the joint of the hole. The edge of the inlay is formed thin edge, which increases the density and sealing effect of the edge of the hole, preventing the dissolution of the adhesion agent and the occurrence of secondary caries. The formation of the slope of the hole should be adjusted according to the direction of the glaze and the mechanical properties of the material. 1/2 the depth of the bevel for enamel commonly wall, hole slope and the width 45 ° Angle, gum wall in the Angle of l0 °. The depth of the hole slant is too large, otherwise affect the depth of shaft wall, reduc