口腔修复学0402（Oral prosthetics 0402）.docVIP

口腔修复学0402（Oral prosthetics 0402） (4) the design of fixed teeth Fixed denture repair is the key to the correct design and elaborate production, study and learn about fixed denture and the stress of the abutment and its supporting tissue, the design of fixed denture, maintain the health of abutment teeth and the prognosis of fixed denture is very important. 1. Stress analysis of fixed denture The structure of the fixed bridge is similar to the general bridge structure, and the reaction of the bridge body and the base tooth is similar to that of the general bridge. Therefore, it can be used to analyze the mechanical principle of mechanical Bridges as a reference for fixed bridge design. (1) simple support for beams: placing a beam across two branches, forming a simple support beam, or simply a beam. When the beam is under pressure, there is a heavy load on both branches. If the stress point is at the center of the beam, the load response of the two points is equal. If the stress point is not at the center of the beam, the weight of the two points is not equal, the more the force point is closer to the bearing point. When the beam is under pressure, the beam is bent downward, and the molecules inside the beam react, the stress response. The inner molecules close to the force side are compressed by the force point, forming internal pressure, which is called the compression zone. The internal molecules on the opposite side of the force point are served to the ends, forming an external tension, called the stretch zone. On the critical surface of the compression zone and the stretch zone, there is a layer of molecules that have neither internal pressure nor external tension. This area is called the neutral plane. Both internal pressure and external tension begin in the neutral plane, and the more the surface becomes apparent. The force at the neutral plane is zero. The internal pressure and the external tension which are the opposite forces are called the flexion stress. Th