导轮安装方法（Guide wheel installation method）.docVIP

导轮安装方法（Guide wheel installation method） Roller maintenance Guide wheel and guide wheel bearing are the key parts of line cutting machine, good precision, good finish, high efficiency depends on a balance, light, precise guide wheel. The maintenance of the guide wheel and the bearing should start from the installation. The tool and assembly environment shall be clean and shall not bring the bearing position into the dirt. It is not allowed to knock and press with heavy pressure in the whole process. The deformation of this installation will completely destroy the original precision of the guide wheel and bearing. Special attention should be paid to the steering wheel in use. When the bearing is not flexible enough or has a foreign body card resistance wheel, the wire will be in the v-shaped slot, and the shape precision of the v-shaped slot will be lost. The bearing work environment is not to be put into sewage, and the impurities are very fast. What is more remarkable is that the bearing and the guide wheel must not flow through the current. If the high frequency power supply is used as the channel, the instantaneous corrosion is very serious. Dirty water, especially the dirty water cut aluminum should be replaced in time. After a few dozen hours of machine tools, be sure to wipe the root of the guide wheel and the bearing sleeve to clear the filling of the sludge. Add a small amount of oil, and let the wire run at full speed for a few minutes, so that the dripping oil can be thrown out with the dirt, then drip into the oil, and so on and so on. Proper assembly, proper use, and effective maintenance of a steering wheel should normally be allowed to take two to three years, and a bearing should be able to make more than half a year. Should pay attention to is currently on the market for the quality of the bearing is very worrying, inner and outer rings of radial runout and axial clearance and wearability of bead and ballistic is not credible, though its packaging and