微波炉的检修（Maintenance of microwave oven）.docVIP

微波炉的检修（Maintenance of microwave oven） The overhaul of the microwave oven. TXT Ming SAO is easy to hide. Buddha said: you two are big silly B! When during the day and a night by turns on the bed, the sun was born for the maintenance of the microwave oven Author: anonymous source: this site finishing release date: 2007-7-8 21:07:50 release: SXDFJQJ Reduces font size and font size And maintenance methods Microwave circuit as shown in the appended drawings, circuit can be seen from the figure includes both primary and secondary, and part of defective work will affect the normal microwave oven. Maintenance and repair, usually based on the transformer primary and secondary industry to judge fault is analyzed. Now boot immediately to burn the fuse, for example, to illustrate the method. First disconnect the secondary high voltage circuit of the high voltage transformer. The transformer secondary high pressure end plug with high voltage capacitor connection point (pulled out). So that can quickly determine the location of the malfunction, and can ensure the safety of repair work. To burn the fuse is caused by some components short circuit inside the machine, but to find a short circuit, which is a component to make further checks. 2 on the original specification of the fuse (6 ~ 10 a) electricity again. Such as fan, rotary motor is normal operation, power control system and transformer are normal, and fault in the system of high voltage circuit. At this time can check the high voltage capacitor (general specification for the 1 u F / 2100 v), special note: be sure to discharge first, then the charge and discharge performance is measured with a multimeter, such as resistance to 0, the short circuit; Or resistance to up, then the loss of charge and discharge performance, there is no high voltage output, microwave oven magnetron without high pressure does not work. To measure high voltage diode, positive value 150 k Ω, back up is normal. Common fault is high voltage capacitor b