最新复习题（The latest problem）.docVIP

最新复习题（The latest problem） The stamping skills review question bank Fills up the topic 1. Three components of stamping processing: punch, mold, material. 2. The progressive die is also called the continuous die. 3. Bending the bending sequence is usually the outer corner and the inner corner after bending. The previous bending should be considered with a reliable positioning of the posterior curvature, and the posterior curvature cannot be formed in the shape of the previous shape 4. In order to prevent deviation when bending, the pressure material and positioning can be used. 5. According to the combination of stamping process, single punching die, compound die and progressive die 6. Separate process mode and multi-process continuous mode according to the stamping process. The parts are made of round corners, light belts, faults, and burrs. 8. To determine the shape and size of the pre-curved blank, the expansion size of the bending parts is calculated. 9. Put the uneven parts into the mould for pressing the process called leveling. 10. The size of the sliding block of the small punching machine determines the size of die die. 11. In the curved deformation area, the inner fiber side is subjected to compression strain and the outer fiber side is subjected to tensile strain, while the neutral layer remains unchanged. 12. Blanking pieces and blanking pieces and the remaining material left by the side of the strip are called lap sides. The quality problems that may arise when stretched are wrinkling and cracking. 14. The process hole is for the production and manufacturing process needs, the addition of holes in the process, rather than the holes needed in the product. 15. The inner hole of the circular washer belongs to the punching shape. 16, take the edge process is a kind of waste, but can compensate the position error and sheet metal width error, really hold parts: qualified on can also improve rigidity of the article, increase productivity, but also can avoid the