标准螺纹螺距（Standard thread pitch）.doc

标准螺纹螺距（Standard thread pitch） Thread, pitch, standard default classification Tooth pitch of metric standard teeth: M1.6-m7 * 0.35 M2 * 0.4 M2.5 * 0.45 M3 * 0.5 The M4 * 0.4 The M5 * 0.8 M6 * 1.0 M8 * 1.25 M10 * 1.5 M12 * 1.75 M14 * 2.0 M16 * 2.0 M18 * 2.5 M20 * 2.5 M22 * 2.5 M2-m24 * 3.0 M27 * 3.0 (* 3.5 M33 * 3.5 M36 * 4.0 Thread profile The method of turning the surface of the workpiece into a thread is called the threading. Thread is divided into three types: triangular thread, trapezoidal thread, square thread, etc. (FIG. 1). The common metric triangular thread is the most widely used. Figure 1 type of thread 1. Basic teeth of common triangular thread The basic teeth of common triangular thread are shown in FIG. 2. The names of the basic sizes are as follows: Figure 2 basic dental type of common triangle thread D - diameter of internal thread (nominal diameter); D - diameter of external thread (nominal diameter); D2 - diameter of internal thread; D2 - diameter of external thread; D1 - internal thread path; D1 - off-thread trail; P - pitch; H -- the original triangle height. There are three basic elements that determine the thread: The Angle of the thread of the tooth Angle alpha thread is the Angle between the two sides of the section. The metric thread alpha is equal to 60o and the English thread alpha is 55o. The pitch P is the distance between the two adjacent teeth in the direction of the axis. The diameter of D2 (D2) is the diameter of an imaginary cylinder of the height H of the flat thread theory. The thickness of the thread in the middle diameter is the same as the width of the slot. Only when the diameter of inside and outside threads is identical, the two can cooperate perfectly. 2. Methods and procedures for cutting outside threads (1) preparing to work 1) when the threading tool is installed, the blade Angle of the turning tool is equal to the thread Angle alpha = 60o, and the front Angle gammao = 0o can guarantee the tooth Angle of the thread of the