树脂再生（Resin regeneration）.docVIP

树脂再生（Resin regeneration） Mixed ion exchanger 1. Internal inspection According to the technology standard of the mixed ion exchanger, the internal device is inspected, and the water condition of the water distribution device, the gap of water cap and the elastic pressure are observed. .2 water flushing, pressure test, leakage and elimination Start clean water pumps, filters, Yang bed, in addition to carbon, Yin bed, open the inlet valve of the mixed bed, exhaust valve, after being mixed with water bed, open is to wash the drain valve of the mixed bed, close the discharge valve, after waiting for is to wash the drain valve of the mixed bed drainage qing, shut down is to wash the drain valve. The cleaning water pump can be used to suppress the leakage and the elimination of the equipment. 3. Filling, processing and recycling of mixed bed resin 1) mixed bed resin filling The hydraulic injector is connected to the mixed bed manhole door, and the strong acid and strong alkali resin are transported to the mixing bed according to the design requirement height (H Yang = 500mm, H mixing = 1000mm). 2) mixed bed resin treatment 10% salt water solution soaked in strong acid, strong base resin: Open the discharge valve of the mixed bed, wash the drain valve, when the water is higher than 100 mm, the resin layer closure is washing the drain valve, and then in salt dissolving tank makes up 10% of the salt solution, through the hydraulic injector send 10% of salt water solution to the mixed bed, strong acid, strong alkali resin soak 12 hours. Start cleaning water pump, intermediate water pumps, filters, Yang, in addition to the carbon bed, Yin bed, open the inlet valve of the mixed bed, exhaust valve, mixed bed filled with water, after open is to wash the drain valve of the mixed bed, close the discharge valve, with inlet and outlet valve of the mixed bed after Cl - almost the same, shut down is to wash the drain valve, stop flush. 5% hydrochloric acid soaking resin: Open into acid