混凝土计算（Concrete calculation）.docVIP

混凝土计算（Concrete calculation） 1. The design value of the axial force is 2650kN and the calculation length is calculated. H = 3.6 m, the concrete strength level is C30 (fc = 14.3 N/mm2), the steel bar HRB400 (fc = 14.3 N/mm2), the environment category is one class. Determine the size and area of the column area. Solution: according to the construction requirement, the section size of the column is assumed to be 400mm by 400mm By ι. / b = 3600/400 = 9, which is psi = 0.99 As = 1 / fy (N / 0.9 bits of fcA) = 1906 was Rho = As/A x400 = 1906/400 = 1.2% rho min = 0.6% For each side of the symmetrical reinforcement section, the reinforcement rate also meets the structural requirements of 0.2%. Choose 4 Φ 25, As = 1964 was The design area and the calculated area error (1964-1906) / 1906 = 3% 5%, meet the requirements. 2. The structure of a multilayer cast-in-site frame plant standard layer of column, axial pressure design value N = 2100 kn, floor high H = 5.60 m, length calculation l0 = 1.25 H, in C30 concrete (fc = 14.3 N/was), reinforced by the level of HRB335 (fc = 300 N/was), environment for categories. Determine the section size and longitudinal area of the column. According to the construction requirements, the section size of the column is assumed to be 400mm by 400mm The length is thinner than the air. B is equal to 17.5, and the table of psi is 0.825 According to the formula of the axial compression bearing capacity, As = 1 / fy (N / 0.9 psi - fcA) = 1801mm2, rho = As/A = 1.1% rho min = 0.6%, and the ratio of each side of the symmetrical reinforcement section meets the structural requirements of 0.2%. Choose 6 Φ 20, As = 1884 was The design area and calculation area error 1884-1801/1801 = 4.6% 5%, meet the requirements. 3. At the bottom of the structure of the cast-in-place cast-in-place structure, the length of the column is calculated. = 4.2 m, cross section size is 300 mm * 300 mm, the column is equipped with 4 Φ 16 longitudinal reinforcement (fc = 300 N/was),