混凝土设计题目（Concrete design topic）.docVIP

混凝土设计题目（Concrete design topic） 1. Chapter 1 the mechanical properties of steel and concrete 1. The larger the test block of concrete cube, the higher the strength. (a) 2. The strength of concrete under three pressure can be improved. (a) 3. The yield strength of normal hot rolled steel is basically the same as that of tensile. (a) 4. The strength and plasticity can be improved after the rebar is cooled. (a) 5. Cold-drawn steel bar should not be used as compression reinforcement. (a) 6. C20 indicates that fcu = 20N/mm. (a) it The tensile strength of concrete increases with the increase of concrete strength grade. (a) 9. The shear strength increases with the increase of tensile stress under the shear stress and normal stress. (a) 10. The elastic modulus of concrete is the same as that of pressure. (a) 11. Linear creep refers to the stress ratio of the stress in the lower part, and the creep is proportional to the stress, while the non-linear creep refers to the increase in the stress in the concrete when the stress is greater. (a) 12. The higher the strength of concrete, the greater the cementation force () 13. Concrete shrinkage and creep are related to time and influence each other. (a) Chapter 3 bearing capacity of axial force member The more the axial compression component, the better. (a) The stirrup of the axial compression member shall be enclosed. (a) There is no real axial compression component in actual engineering. (a) The larger the length of the axial compression component, the higher the stable coefficient value. (a) In the calculation of the axial compression component, the longitudinal reinforcement is easy to curve when the pressure is under pressure, so the design value of the compressive strength of the reinforcement is the maximum. (a) 6. The spiral stirrup can improve the bearing capacity of the axial compression component and improve the stability of the column. (a) Chapter 4 is the bearing capacity of the bending member The larger the thickness