继电保护（Relay protection）.docVIP

继电保护（Relay protection） Fill in the blanks 1. In the neutral point grounding grid, the use of malfunction when one-phase ground fault circuit zero sequence current and the fault circuit zero sequence current direction different characteristics, can form of protection are (zero sequence directional protection). 2. The protection of the instantaneous action of the increase of the reaction current is referred to as (no time - time current loss protection). 3. The time limit for the fixed time limit for current protection is selected according to _ (guaranteed selective staircase protection). 4. The zero sequence overcurrent protection is compared with the current protection compared with the current protection, because the action current is small, so the sensitivity (high) _. Ⅱ paragraph 5. Distance setting impedance should press branch coefficient Kb for minimum operation mode to determine, the purpose is to ensure (optional). 6. Zero sequence current protection and (zero sequence voltage protection) for neutral or ungrounded transformers are required. 7. When a short circuit failure occurs in the power system, it is usually accompanied by an increase in current, voltage (decrease), and the phase change between current and voltage. 8. The relay protection device is generally composed of the measuring part, the logical part and the (executing output element). 9. Protection of directional elements on the basis of current protection is referred to as (directional current protection) 10. When the power system fails, the relay protection device shall (cut out the point of failure), when the power system fails to work normally, the relay protection device shall generally (alarm). 11. Current protection experience (represented by the fuse) (in electromagnetic type) (ground protection) (microcomputer protection) 4 stages. 12. The number of neutral grounding transformer is large, the system (high stability), grounding fault point (frequency decrease). The total length of the l