规范停车位（Standard parking）.docVIP

规范停车位（Standard parking） Industry standards of the Peoples Republic of China Design Code for Garage JGJ100-98 Chief editor: Beijing construction engineering college Approval department: ministry of construction of the Peoples Republic of China Effective date: 1 September 1998 (record) 1 the general 2 terms 3 base and total plane 3.1 library site 3.2 the total plane 4 ramps garage 4.1 general provisions 4.2 design of ramps garage Mechanical garage 5.1 general provisions 5.2 mechanical garage design 6 building equipment 6.1 general provisions 6.2 water supply and drainage 6.3 heating ventilation 6.4 electric Appendix A is A description of the specification 1 the general 1.0.1 in order to meet the needs of urban construction and development, it is necessary to make the automobile library building design conform to the basic requirements of use, safety and sanitation, and make this specification. 1.0.2 the specification is applicable to new construction, expansion and reconstruction of garage building design. 1.0.3 building design should be convenient, advanced technology, safe and reliable, economical and reasonable and meet the requirements of urban traffic modernization management and urban environmental protection. 1.0.4 the building scale of the garage shall be divided into four categories according to the type and capacity of the car and shall be in accordance with the provisions of table 1.0.4. Classification table of garage buildings 1.0.4 Large scale large medium sized small size Number of stops (a) 500 301 ~ 500 51 ~ 300 50 Note: this classification is applicable to the grade car depot and lift truck depot of medium and small vehicles, and other mechanical garage is not applicable. In addition to this specification, the building design of 1.0.5 garage should meet the relevant standards of the state. 2 terms 2.0.1 Garage Parking and storage of car buildings. Minimum turn radius of car The radius of the path of the front wheel of a car in the front wheel of a c