车基本保养指南（Basic maintenance guide）.docVIP

车基本保养指南（Basic maintenance guide） Basic car maintenance guide The car owner cannot drive to the service station every day after all, so should also master some simple maintenance skill. Motor oil level inspection technique process When the engine is at work temperature, turn off the engine and check the oil level. 1. To get accurate oil level readings, park the vehicle on a flat surface and turn off the engine for a few minutes to bring the oil to the bottom of the engine. Pull out the oil ruler and wipe with cloth. 3. Re-insert the gauge ruler -- try to insert it as far as possible, otherwise the reading will be inaccurate. 4. Pull out the gauge and check the oil level of the oil gauge. If the oil level is lower or slightly higher than the low oil level, the same type of motor oil must be added to the engine. Remove the oil filling cap. Add a small amount of oil and check the gauge. The amount of oil that needs to be injected is the approximate amount of oil between the low oil level line and the high oil level line. When the oil level reaches the correct range, install the oil cover and tighten it with the hand. Oil volume, L (L) : 1.5 Matters needing attention Dont run into a high temperature exhaust pipe. Avoid too much gas or the engine will be damaged. After refueling, check the oil level on the gauge. Oil selection Use API grade SJ Energy - Conserving, SL Ener Conservi inverse ng or ILSAC multi-grade oil. Prediction temperature before oil change: 18 degrees to 38 degrees, you can choose 10w-30, 13 to 38 degrees, the choice is 15w-40, 7 to 38 degrees, you can choose 20W - 50. Add engine coolant fluid process Check the transparent coolant box during engine cooling. Coolant level if they remain in the liquid box F and L tag line, meets the requirements, if the liquid level is low, must join the glycol type coolant, in order to make the aluminum parts properly anti-corrosion protection. The liquid level of coolant in the tank will vary with the temperature of the