车间安全检查表（Shop safety check list）.docVIP

车间安全检查表（Shop safety check list） Shop safety check list The workshop is the main production site of the enterprise, and the working environment, safety management and safety production of the workshop are closely related, so it must be paid enough attention to not be negligent. At the same time, the more unsafe behavior should be strictly, strengthening, control, to improve safety awareness and self-protection capability, workers make unsafe ACTS to reduce the risk to a minimum, to do prediction prevention, so as to achieve the best security status. 1. Operating environment Inside and outside the workshop should be neat, clean and smooth 1.2 in accordance with the provisions of gb2894-82, safety marks or speed limits shall be set in accordance with the conditions of the workshop and the area of operation. 1.3 the site of the operating area shall be orderly, non-skid, non-concave, convex and serious oil pollution; 1. No simple buildings shall be erected within the workshop. If special circumstances must be constructed, they shall be approved by the relevant departments and the term of use shall be stipulated and shall be removed immediately after use. 1.5 channel width should be in accordance with the following rules. The width marking line should be painted with paint and be clear. The pedestrian channel is greater than or equal to 1.8m; The channel is larger than or equal to 3m; The vehicle or forklift channel is greater than or equal to 3.5 m. 1.6 the rail top of the railway line entering the workshop shall be flush with the ground. The plant should have good natural ventilation and natural lighting. Natural lighting should not be less than 50Lx. The workshop should set general lighting, local lighting and accident lighting. 1.9 if the normal lighting is extinguished after the failure, in the place where the accident is easy to cause injury or dangerous, the accident lighting shall be installed for the evacuation of personnel. 1.10 after the normal lighting has be