轮机工程（Marine engineering）.docVIP

轮机工程（Marine engineering） The new topic added 1. (C) the increase of vacuum degree of the pumps allowable suction is: A. reduce atmospheric pressure b. increase pressure drop C. Reduce liquid density d. raise liquid temperature 2. (C) the vacuum degree of the pump will be reduced by: A. increase atmospheric pressure b. reduce pressure drop in pump c. increase liquid density d. reduce liquid temperature 3. (D) the relative speed of the liquid between the two blades when the flow of the pump is less than the design flow in the actual work: A. will increase b. will decrease c. to meet the water surface, to reduce the surface of the water 4. (C) the relative speed of the liquid between the two blades when the flow of the pump is greater than that of the design flow. A. will increase b. will reduce c. to meet the surface of the water 5. (A) in order to obtain A large centrifugal pump head, the unlikely route is: A. Improve the export a2 B of the impeller. Reduce the exit a2 C. Increase the outer diameter D. Increase the speed 6. (B) in order to obtain a large centrifugal pump head, the possible route is: A. Improve the export a2 B of the impeller. Reduce the exit a2 C of the impeller. Reduce the outer diameter of the impeller 7. (D) when the centrifugal pump sends liquid viscosity increases, _____ will not increase. A. Flow resistance B. Disc friction loss C. Friction loss along the path. D. Impact loss 8. When the centrifugal pump delivers more liquid viscosity, the loss of _____ increases. A. impact b. disc friction loss c. leakage d. vortex 9. (A) volute centrifugal pump, when the flow rate is greater than the rated flow rate, the change of liquid pressure in the pump is as follows: A. From the tongue of the pump to the diffused pressure pipe gradually decreased b. from the tongue of the pump to the expansion of the pressure tube gradually increased c. the same d. not necessarily 10. (B) volute centrifugal pump, when the flow rate is less than the rated flow rate, the