软弱下卧层（Soft sleeper）.docVIP

软弱下卧层（Soft sleeper） What are the requirements for the foundation bearing capacity of the foundation? Questioner: 39012574238 | number of views: 610 times The best answer of 2010-11-25 09:25 shall meet the provisions of article 3.0.4, 4.2.3 and 4.2.4 of the construction foundation treatment technology. 3.0.4 after treatment, when the foundation floor area is determined by the bearing capacity of the foundation and the depth of the foundation shall be fixed, the fixed bearing capacity of the foundation shall be revised in accordance with the following provisions: The foundation bearing capacity correction coefficient of foundation width should be zero; The foundation bearing capacity correction factor of foundation buried depth should be 1.0. After treatment, it is necessary to check the foundation bearing capacity of the sleeper bed when there is still a soft lying layer within the range of the stress zone. The strength of pile strength should be calculated according to the modified composite foundation bearing capacity. 4.2.3 the bearing capacity of the cushion shall be determined by the field load test, and the calculation of the soft sleeper layer shall be carried out. 4.2.4 in the case of the building under the cushion under the cushion, the influence of the adjacent foundation on the stress superposition of the top surface of the soft sleeper should be taken into account in the calculation of foundation deformation. When the above ground level is higher than the ground level or the material is heavier than the natural soil layer, it is advisable to change the filling and the effect of the additional load on the building and adjacent buildings should be considered. 1. Estimation formula: Ac = Nc/(a * fc) Where: a - axial compression ratio (0.7, 0.8, 3, 0.9, short column 0.05) Fc - concrete axis compressive strength design value Nc - - estimate column axial force design value 2. Design value of column axial force: Nc = 1.25 C beta N Among them: N - - - vertical l