轴承的装配方法（Assembly method of bearing）.docVIP

轴承的装配方法（Assembly method of bearing） Whether the bearing is installed or not will affect the bearings accuracy, life and performance. Therefore, please fully study the installation of bearing, i.e., bearing installation according to operation standard including the following items. 1. Clean the bearings and related parts of the bearing and the two sides with oil seal or dust cover, before the sealing ring bearing installation. Second, check the size of the related parts and finish machining Three, installation method of bearing installation should be according to the bearing structure, size and cooperate with properties of bearing parts, pressure should be directly in the tight fit on the ring width, shall not be passed on roller pressure, bearing installation commonly adopt the following methods: a. force fit bearing inner ring and shaft tight fit, outer ring and bearing hole is a loose fit, press the bearing to be pressed on the shaft are available, and then put the shaft together with the bearing load bearing hole, when pressed on the bearing inner ring end face, cushion the assembling casing made of a soft metal material (copper or mild steel), the inner diameter of the casing assembly should be slightly larger than the diameter of a journal, outside diameter than the bearing inner ring guard slightly smaller, in order to avoid pressure in keeping the frame. When the bearing outer ring and the bearing hole are tight fit together, the inner ring and shaft are relatively loose, and the bearing can be pressed into the bearing hole. The outer diameter of the assembly casing should be slightly less than the diameter of the hole. If the bearing ring and the shaft and the seat hole are tight fit, the mounting of the inner circle and the outer ring should be pressed into the shaft and the seat hole. The structure of the assembly sleeve should be able to hold the inner circle and the end surface of the outer ring simultaneously. B. Heating with heating bearing or bearing