轧钢工艺流程图（Flow chart of rolling process）.docVIP

轧钢工艺流程图（Flow chart of rolling process） China henan gongyi rolling machine manufacturing co. LTD Hot dip galvanizing production line, yield 30,000 to 200,000 tons/year Continuous hot galvanizing line The cold and hot rolled steel plates are defatted by alkaline cleaning, and then the horizontal heating furnace which is heated by the radiation tube will be annealed after being washed and dried. A certain amount of hydrogen will be added to the furnace to cause the atmosphere to be reduced. Heat up to a certain temperature The steel plate, under the protection of N2 and H2, is cooled to a certain temperature and dipped in zinc under closed conditions. The steel band that enters the zinc liquid comes out from the pot and USES the air knife to control the galvanization and the zinc is large Small composed of liquid zinc components to control at the same time, adopt the method of forced cooling to control, the small zinc products before zinc flowers grew up, with a small spangles equipment quench prevent spread of liquid zinc, zinc form small flowers. After hot galvanizing, the steel strip is cooled and the surface light is finished, and finally the surface passivated or directly produced into hot-dip galvanized coil plate according to the use. · strip thickness of 0.14 to 2.0 mm · coating: ordinary coating, small zinc, pure zinc, zinc aluminum alloy, pure aluminum, zinc-iron alloy · coating quality: improved quality, high grade painting board · protective coating: chemical passivation, oil coating, fingerprint resistant coating, organic coating China henan gongyi rolling machine manufacturing co. LTD The first section of the process flow chart of section rolling process 1 page China henan gongyi rolling machine manufacturing co., LTD Color coating production line, yield 30,000 to 250,000 tons/year The surface status of the plate (GI, EGI, GL, CR, etc.) was treated with the alkaline washing, washing and drying of the pretreatment equipment, and then the chromating of chro