道路测量（Way to measure）.docVIP

道路测量（Way to measure） Section 1 personnel organization and equipment allocation I. personnel organization 1 professional surveying and mapping engineer, 8 certified staff and post surveymen responsible for field measurement work. 2. Equipment The project is intended to be equipped with TOPCO complete station N211D, laser theodolite (JZ2) control, detection axis and perpendicularity; With the control of the 8 level (dzs3-1) type automatic anping level, the test level is high and the level of flatness, and the elevation transmission adopts the combination of the standard long steel ruler and the water level. Starting from the entry, coordinate with the project schedule to carry out the alignment of the axis and the control of the elevation. Section 2: positioning line First, the working conditions 1. Conditions of construction survey operation. 2. The network diagram and other information are ready. 3. The measuring instrument is in good condition after school inspection. 4. The construction site has been leveled and the ground obstacles have been cleared. 5. The red line of construction planning has been released and is well preserved. 6. Surveyor has been familiar with architectural planning red line chart and master plan, building planning red line spacing conform to the requirements of the local city planning, the feature points and calculate the building planning red line and the distance between the size correct labeling on the construction site plan. 7. The surveyor has determined the method and procedure for measuring the discharge line. Materials and instruments used 1. The surveying engineering mainly USES some scattered and auxiliary materials, including: red brick, white ash, wood pile, iron nails, steel bars, paint, drawing, water, sand, gravel, cement, etc. 2. The measuring engineering mainly USES three instruments: the laser theodolite (JZ2), the water level (DZS3-1), and the TOPCO type total station N211D. 3. The work (with) mainly has: small tape 5 m a