采用先进控轧控冷技术生产高强度宽厚板（The advanced control cold technology is used to produce high strength and wide plate）.docVIP

采用先进控轧控冷技术生产高强度宽厚板（The advanced control cold technology is used to produce high strength and wide plate） The advanced control cold technology is used to produce high strength and wide plate Zhao si xin, yao liandeng (baoshan iron steel co., LTD., Shanghai, 20, 19, 0) The paper reviews the situation of the high strength steel plate of advanced control cold and on-line heat treatment in foreign countries It is. The control rolling process and control of baosteel are introduced The control process of high strength and thick plate is produced by cold process. By adopting advanced control cold technology, baosteel produced yield strength of 550mpa and 690 MPa and high strength steel plate with good low temperature toughness, the plate thickness can reach 80 m m, and it has good welding performance, 40 m m thick Q 6 90 CF steel plate can be real Do not preheat the welding. This paper discusses and prospected the future development of cold technology and products. Key words control cold, high strength steel, broad plate, direct quenching 1 introduction The development of control rolling and control cooling technology is divided into several stages: before the 1950s, the control of rolling technology research began; In the 1960s and early 1970s, the exploration and deepening of rolling technology were controlled. Control of rolling control has been controlled since the late 1970s Cooling technology is widely used worldwide: control of rolling control cooling technology is widely used to refine grain, improve strength and improve toughness Purpose []. After the 1980s, the junjin plank adopted C L C, JF E adopted O L A C The water island plate USES MA C S, gargu The sichuan plank adopts K C L , The company of PO S C O adopted MU LPIC, etc. [2]. The cooling mode has the passing type (p r o g r e s iv e) Synchronous type (Sim u l - T a, n, e. U s) , Cl OS Ed and non-binding (Op en) It is. In recent years, direct quenching technology has developed rapidly, and steel of differen