关于TA17合金冷轧板材表面条状裂纹缺陷成因分析.PDFVIP

第34卷第1期 钢摇 铁摇 钒摇 钛 Vol.34,No.1 2013年2月 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 IRON STEEL VANADIUM TITANIUM 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 摇 February2013 合 TA17 合金冷轧板材表面条状裂纹 缺陷成因分析 黄德明,杨雄飞,韦青峰,陈摇 永,郭摇 华,蒋仁贵 (攀钢集团研究院有限公司,钒钛资源综合利用国家重点实验室,四川 攀枝花617000) 摘摇 要:针对TA17合金冷轧板材表面沿着轧制方向出现的大量条状裂纹,利用体视镜、扫描电镜及能谱仪进行分 析。 形貌分析表明:裂纹多呈现锯齿状,长度一般在10 ~30 mm,深度很浅,小于10 滋m,且无明显的裂纹尖端。 成 分分析表明:裂纹处氧元素含量高,但完好的表面无明显的氧元素存在。 判断裂纹的出现主要与冷轧板表面残留 氧化层有关。 关键词:钛合金;TA17;冷轧板;表面条状裂纹 中图分类号:TF823,TG146郾23摇 摇 文献标志码:A摇 摇 文章编号:1004-7638(2013)01-0026-05 DOI:10.7513/ j.issn.1004-7638.2013.01.006 Cause Analysis of Strip Cracks on Surface of TA17 Alloy Cold鄄rolled Sheet Huang Deming,Yang Xiongfei,Wei Qingfeng,Chen Yong,Guo Hua,Jiang Rengui (Pangang Group Research Institute Co. ,Ltd. ,State Key Laboratory of Vanadium andTitanium Resources Comprehen鄄 sive Utilization,Panzhihua617000,Sichuan,China) Abstract:Strip cracks along rolling direction on the surface of TA17 alloy cold鄄rolled sheet were ob鄄 served by stereoscope,SEM and EDS. Morphology observation indicated that cracks were dominantly in zigzag shape,with 10~30 mm in length and less than 10 滋m in depth,and there was no evidence of crack tips. Chemical composition analysis showed that crack regions were characterizd by high oxygen concentration while theintact surfacewasat normal oxygenlevel. Testresultssuggestthattheoccurrence of strip crackswere mainly related to residual oxide on the surface of TA17alloy cold鄄rolled sheet. Key words:titanium alloy,TA17,clod鄄rolled sheets,surface strip cracks 砂对合金的强度、塑性和低周疲劳性能无影响。 0摇 引言 TA17合金由苏联普罗米修斯中央结构材料科学研 摇 摇 TA17 合金是一种三元钛合金,名义成分为Ti-