2只老虎（Two tigers）.docVIP

2只老虎（Two tigers） The main content of injection mould design: 1) firstly, determine the parting surface, and the core structure should be selected by the side core. 2) determine the form of the cavity number and the shape of the cavity and the core structure; 3) gate position, the determination of the dewatering path structure and the determination of the exhaust system; 4) orientation, determination of positioning structure; 5) selection of structure and reset structure; 6) selection of mold size and selection of relevant standard parts; 7) injection machine number, specification selection. After the above content is confirmed, the design and drawing of the general assembly drawing can be carried out. The main process parameters of the mouse mould are determined Determine key process parameters of mouse mould, such as The design of the pouring system is designed using a gating system with a point gate and a balanced symmetrical arrangement is adopted. The design of the deformable mechanism is designed according to the analysis of the mouse plastic parts. The design of the mold guide mechanism, The guide is usually guided by a guide and its main parts are the guide and guide. (4) the mold temperature control for thermoplastic injection molding mold, when faced with illiquid plastic molding (e.g., high crystallization of plastic forming parts), and using hot runner mold would need to be heated; The determination of the number of mold cavity of the mold, according to the analysis of the plastic parts of the mouse, adopt a two-cavity; With the determination of the shape of the plane, select the largest part of the shell of the mouse, which is the bottom edge of the upper shell. The method of the core pumping is analyzed according to the plastic parts of the mouse, and the inclined guide column is used to draw the core. The checking of relevant data The structure design and calculation of the mouse shell and its dies mainly include: (1) the volume and weight of the produ