375调试费希尔定位器（Debug fisher locator）.docVIP

375调试费希尔定位器（Debug fisher locator） Use the 375 field communicator (manual operator) to check DVC6020 quick start One, 375 and the HART loops join 375 can communicate with any terminal connector in the control room, instrument field or loop. To connect the 375 and appropriate connectors to the instrument or load impedance parallel, HART wiring is not sensitive to polarity. For the 375 to be positive Regular work, at least 4mA current and 12VDC voltage at the site equipment terminal (DVC), HART The impedance in the loop shall not be less than 250 ohms. There are three ports on the top of 375. Two of them are red and one is black. The two red ports are the pros of their respective agreements. The black port is the common side of the two protocols. The cover device can ensure that only one pair of ports are exposed at any time, see the image below. There are multiple tags, Indicate which pair of ports corresponds to which protocol, and the DVC on the anti-surge valve is HART. Ii. Start the 375 - type live communication device After the HART loop is connected, the DVC signal (using a signal transmitter or a PLC/DCS power supply card), To ensure normal communication, the DVC must have at least 4mA current 12VDC voltage. Press open/key, until the multi-function LED indicator is flashing, indicating that the device has been on (for about two seconds). See figure 2-2 for the open/key location. During startup, 375 will automatically install all upgrade software on the system card. After completion, you will show the main menu of 375, and you can select HART Application (start HART Application). 2. FOUNDATION Fieldbus Application (startup FOUNDATION Fieldbus Application) 3. Setting (configuration/viewing Settings) 4, Listen For PC (entering PC control mode) 5. ScratchPad (launch ScratchPad app) 3. Shutdown when the application opens, the key is disabled. Before you use the open/key, you must return to the main menu of 375. If you want to close the 375, hold off/key until the di