建筑测量（Construction survey）.docVIP

建筑测量（Construction survey） One, single question (36 points for each question) The datum is the level of the earth. A. Vertical Angle b. elevation C. Horizontal distance D. Horizontal Angle 2. When the level measurement is measured, the reading of the reading after the reading of the station is not centered, and the observer will be able to observe the observation before the observation. The operation procedure (or treatment method) is (B). A. allowed b. absolutely not allowed C. Sometimes its ok 3. The basic formula for the calculation of the check nucleus is (C) when the data is collected. 4. In the leveling, month from point A to point measurement, measured the elevation difference between two points on A 0.698 m, and B level ruler reading of 1.376 m, then A level ruler readings for m (B). A. 0.678 b.2.074 C. 0.698 d. 1.376 5. Below is the reading window of a theodolite reading for (B). 6. When measuring the vertical Angle with the theodolite, each reading must rotate (D) to center the level-pipe bubble. A. Telescope micro spiral B. Horizontal microdynamic spiral C. Foot spiral D. Indicator level tube microdynamic spiral To measure the horizontal Angle of the test, the initial position of the change dial is to eliminate (D) error. A. Visual axis b. horizontal axis C. Index differential D 8. The direction of the month is 210.4 Lin, and the return measurement is 210.35 m, and its relative error is (B). A. 1/3000 B. 1/3500 C. 1/4000 d. 1/5000 9. The measurement of distance measurement results in the (A) of two points. A. Horizontal distance b. slash distance C. Line distance D. Lead vertical distance 10.1: the scale accuracy of the topographic map is (C). A. 0.05 m b. 0.1 m 0.0.0.0.5 m 11. To choose a route with a vertical gradient of no more than 2%, the height of the set is 2m and the scale of the topographic map is The route passes through the shortest distance of two adjacent contour lines (B). A. 50m b. 100m C.150m d. 200m 12. The data required to measure the pla