51单片机AD转换.TXT（51 MCU AD conversion. TXT）.docVIP

51单片机AD转换.TXT（51 MCU AD conversion. TXT） The definition of ADC; / / port Ad_cs, equ, P3.6, chip selection Ad_wr equ P2.0; conversion begins Ad_rd, equ, P3.7, RD=LOW, digital signal output Ad_input_port equ P1; define data bits Counter EQU 59H; the counter tells the program to know which digital tube it is displaying through it FIRST, EQU, P2.4: bit control of the first bit digital tube SECOND, EQU, P2.5, bit control of second bit digital tube THEER, EQU, P2.6, bit control of third bit digital tube DISPBUF EQU 5AH; display buffer for 5AH and 5BH Org 0000H Ajmp main ORG 000BH; the entrance of the timer T0 AJMP DISP; display program Org 0080h Main: MOV, SP, #5FH; setting the stack MOV, P1, #0FFH MOV, P0, #0FFH MOV, P2, #0FFH; initialize, monitor, LED out MOV, TMOD, ; timer T0 operates in mode 1 (16 bit timer / count mode) MOV, TH0, #HIGH (65536-2000) MOV, TL0, #LOW (65536-2000) SETB TR0; turn on timer 0 SETB EA; open total interrupt SETB ET0; open timer 0 interrupts MOV, Counter, #0; counter initialization LOOP: Lcall adc_demo; call the AD subroutine Ajmp LOOP //==========================================; Start the AD conversion; / / //==========================================; Adc_Start: CLR ad_cs NOP CLR ad_wr NOP Setb ad_wr NOP Setb ad_cs NOP Ret //==========================================; Read / / AD conversion; //==========================================; Adc_Read: MOV, ad_input_port, #0ffh CLR ad_cs NOP CLR ad_rd NOP NOP MOV, a, AD_INPUT_PORT NOP Setb ad_rd NOP Setb ad_cs Ret //==========================================; AD conversion; / / read delay procedures, display the value read //==========================================; Adc_Demo: Lcall Adc_Start Lcall delay1ms Lcall adc_read MOV, B, #100; AD converted values, except 100 for 100 digits DIV AB; take hundreds of digits in the B register MOV, DISPBUF, A; store 100 bits in one hundred bit registers DISPBUF MOV A, B A; sending the remainder MOV, B, #10; the remainder is the ten digit except the