一般编程技巧 档（General programming skills）.docVIP

一般编程技巧 档（General programming skills） General programming skills The differences and programming techniques of several common instructions in CNC machining center With the development of science and technology and the progress of society, the quality and quality of products are getting higher and higher It has been popularized to a certain extent, and high performance and high efficiency machining centers have gradually become necessary. Through several years of processing Central practical application and teaching practice and exploration, the author will sum up their experience and experience, I hope for readers to start Di. 1. pause instruction G04X (U) _/P_ refers to the time when the tool is stopped (the feed stopped and the spindle does not stop) and the value after the address P or X is suspended Between. The value behind X should be accompanied by a decimal point. Otherwise, 1/1000 of this value is calculated in seconds (s), followed by the value of P Cannot take a decimal point (that is, an integer representation) in milliseconds (MS). For example, G04 X2.0; or G04 X2000; pause for 2 seconds G04 P2000; But in some hole processing instructions (such as G82, G88 and G89), in order to ensure the hole bottom roughness, when the tool is machined to the bottom of the hole When there is a pause time, the address P can only be used at this point. If the address X is used, the control system considers X to be the X axis coordinate value Execute. For example, G82X100.0Y100.0Z-20.0R5.0F200P2000; drilling (100.0100.0) to the bottom of the hole for 2 seconds G82X100.0Y100.0Z-20.0R5.0F200X2.0; drilling (2.0100.0) to the bottom of the hole will not be suspended. The differences and connections between 2.M00, M01, M02 and M30 M00 is a program with unconditional pause instruction. The program executes to this end of the feed, and the spindle stops. To restart the program, you must first return it Shi OG, press CW (spindle turning) start spindle, then return to the AUTO state