skp使用技巧（SKP skills）.docVIP

skp使用技巧（SKP skills） 1, when you select, double-click a separate surface, you can select the same surface and the line forming the face. 2, double click on the surface of an object, you can choose the face and line, three hit the object on a surface, you can choose all the faces and lines of the object. 3, the use of roaming commands and camera commands, you can enter in the lower right corner of the input box to enter the height of the line of sight. 4, the use of dynamic zoom command, you can enter the number of Deg (example: 60Deg) to adjust the camera angle. 5, the use of dynamic zoom command, you can enter the number of Mm (example: 35mm) to adjust the camera focal length. 6, the object into groups or components, you can right-click in the menu inside the axis mirror phase, select the mirror phase mode. 7, select objects, scaling the command, select the direction of scaling, then enter -1, you can mirror objects. 8, use push and pull command once, next time use push and pull command, double click can repeat last size. 9, select the object, press and hold Ctrl, you can increase the choice, press and hold shift, you can add and subtract, select, while holding down Ctrl and shift for less choice. 10, shift+ mouse middle key for pan function. 11 hold the shift while locking in one direction (such as parallel, polar axis, etc.) to keep this lock. 12, select the state click object is selected line or plane is double line and surface and three Click to press the CTRL object selection of vehicle mobile copy command can be directly copied object if the object has a set of words copied objects are still in the same group use eraser can only delete the line and not so if you want to delete delete face on one side of the line with a messy eraser than the marquee object after using the DEL command is convenient. 13, roller + left key is pan, oh, pay attention to the wheel, press the left key. 14, in the copy movement (by CTRL copy), enter the value of x/, such as input 5/, t